HP 6200 User Manual

Page 91

Connect the power cable (1) and data cable (2) to the back of the hard drive.

NOTE:

The power cable for the hard drives is a two-headed cable that is routed from the

system board to the rear of the hard drive bays.

Figure 3-32

Connecting the Hard Drive Cables

If installing a new drive, connect the opposite end of the data cable to the appropriate system
board connector.

NOTE:

If your system has only one SATA hard drive, you must connect the hard drive data

cable to the dark blue connector labeled SATA0 to avoid any hard drive performance problems.
If you are adding a second hard drive, connect the data cable to the light blue connector (8200
Elite models) or the white connector (6200 Pro models) labeled SATA1.

10.

Route the power and data cables in their cable retainers.

11.

Replace the computer access panel.

12.

Reconnect the power cord and any external devices, then turn on the computer.

13.

Lock any security devices that were disengaged when the access panel was removed.

ENWW

Installing and Removing Drives