Humax COMBO-9000 - Manual (Page 59)

GB58
User’s Manual
7. Installation
7.3 Software Update
In order to maintain proper performance of the product, it is essential to have the most up-to-date
software. Visit the Humax website to check the latest news and newly released software versions.
– http://www.humaxdigital.com.
It is recommended that you periodically check for the availability of software update.
1. Press the MENU button.
2. Select Installation using the / button and press the OK
or button.
3. Select Software Update using the / button and press
the OK or button.
1. OTA (Over The Air)
OTA, an abbreviation of Over–the-Air, is a standard for the transmission of software through a
broadcast system. OTA is simply an alternative method for downloading software versions. However, the
manufacturers reserve the right for deciding the release of the software for their products by beaming the
latest version of software over the air via aerial. The software update via aerial will only occur under the
following circumstances.
1. The equipment should have the appropriate loader software.
Caution: Please note that if the normal loader software is not equipped, the product may not be
updated or operate properly after software update.
2. The manufacturer decides to release the software via a designated channel.
3. The equipment must be tuned properly to the same aerial equivalent to that of the manufacturer.
4. Update software when the signal strength and quality is high. If the signal strength and quality are not
recommendable, perform the software update later.
Caution:
• Please be careful to keep the power on and the power cord plugged in during software update. If the
power is off during software update, fatal damage may be caused to the product.
• Please be careful not to pull out the signal line (co-axial cable) during software update. Update may be
interrupted and the product may not operate.