Humax COMBO-9000 - Manual (Page 56)

7. Installation
GB55
User’s Manual
Installer Menu
1. Select Installer Menu using the / button and press the
OK or button to set default setting and operation limit
for motor antenna.
2. Select Motor Limit using the / button and press the OK
or button to select Enable/Disable. To save the present
location, change the Motor Limit to Enable.
Enable
Motor limit is set. motor does not exceed
the limit.
Disable Setting is released.
Note:
• When
Motor Limit is set to Enable, Limit Position and Set Limits are set to Disabled.
• When setting new motor limit, set to Disable.
3. Select Limit Position using the / button and press the OK or button to select East/West.
4. Select Set Limit using the / button and press the / button to move the antenna to the limit
position.
Note: When limit is set, Motor Limit is automatically set to Enable.
5. Select Reset Positions using the / button and press the OK button to restore the position saved at
motor antenna to the factory default. A pop-up will appear. Select OK and press the OK button. Please
wait while the motor antenna is restored.
Note: Reset may not be activated depending on the condition of the antenna. Repeat the procedure
above if necessary.