Epson 8100i - Manual (Page 29)

Setting Up the Projector 23
4. To use the EMP Link V software, or to program new effects for
the Effects buttons on the remote control, connect one end of the
PC serial cable to the
SERIAL terminal on the main cable.
5. Connect the other end of the serial cable to the serial port on the
back of your computer.
6. Tighten the screws on the connectors.
Connecting the Audio Cable
1. If you’ll be using audio, connect one end of the 3.5-mm audio
cable to the Audio port on the projector.
2. Connect the other end of the audio cable to your laptop’s
headphone jack. (Jack locations vary; see your computer manual if
you’re not sure of which jack to use.)
note
You won’t be able to use
EMP Link V if your laptop
has only one serial port that’s
being used to support a serial
mouse.
audio cable
Audio port