Epson 8100i - Manual (Page 24)

18 Setting Up the Projector
3. Connect one end of the computer video cable to the projector’s
Computer 1 (VGA) port.
4. Make sure the DVI/VGA
switch on the back panel is
flipped to the right, as shown.
If necessary, use the tip of a
ballpoint pen to slide it over.
5. Connect the other end of the
computer video cable to the computer’s video port.
6. Tighten the screws on the connectors.
Connecting the Mouse and Serial Cables
To use the remote control as a mouse or use the EMP Link V
software, follow the steps below. This illustration shows the
connections you’ll be making:
1. Connect the round end of the main cable to the projector’s
Mouse/Com port, as shown.
Computer 2 / Component Video
Computer 1
R/Cr/Pr B/Cb/Pb H/C Sync V Sync G/Y
DVI/VGA switch (slide to right)
main cable
9-pin serial cable PS/2 or USB cable
Mouse/Com port