Enterasys Networks 802.1Q - Manual (Page 53)

Protocol Ports Configuration Screen
VLAN Configuration 3-31
3.9.1 Adding/Deleting Ports Associated with a VLAN ID
To add or delete ports from a VLAN, proceed as follows:
1. Use the arrow keys to highlight the Port field.
2. Press the SPACE bar to step to the appropriate port number. The associated protocol is
displayed for that port.
3. Use the arrow keys to highlight the DELETE ALL PORTS field.
4. Press the SPACE bar to step to the appropriate selection to ADD PORT, ADD ALL PORTS,
DELETE PORT, or DELETE ALL PORTS from the VLAN ID shown in the VLAN ID field.
5. Use the arrow keys to highlight the SAVE command at the bottom of the screen.
6. Press ENTER. The message “SAVED OK” displays and the settings are saved.
Port
(Selectable)þ Step through the ports to select a port to add of deleted from the
VLAN ID shown in the VLAN ID field. When a port is displayed the
associated port type is displayed to the right of the port number. In
Figure 3-10 , the port is 31 and the associated port type is, ATM PVC
VCI-1 VPI-23.
DELETE ALL
PORTS (Selectable) Add or delete a port selected in the Port field of the VLAN ID
displayed, or add all ports to, or deleted all ports that are configurable
on the device. All ports includes, all physical and virtual ports such as
ATM ports if supported. In
Figure 3-10 , the priority is “0”. The
selections are as follows:
ADD PORT – adds the port selected in the Port field.
ADD ALL PORTS – adds ALL PORTS that are configurable to the
VLAN ID shown in the VLAN ID field.
DELETE PORT – deletes the port selected in the Port field.
DELETE ALL PORTS – deletes ALL PORTS that are configurable
from the VLAN ID shown in the VLAN ID field.
Table 3-7 Protocol Ports Configuration Screen Field Definitions (Continued)
Use this field … To …