Epson Artisan 837 - Manual (Page 28)

28 Maintaining Your Product
7. Insert the new cartridge into the holder and push it down until it clicks into place.
8. Once you replace all the cartridges that need replacing, close the scanner to begin
charging the ink. This takes about 2 minutes. When you see a completion message on
the display screen, ink charging is finished.
Caution: Never turn off your product while ink is charging or you’ll waste ink. If you
see an ink replacement message on the LCD screen, press OK and press down all
the cartridges securely. If you remove a low or expended ink cartridge, you cannot
reinstall and use the cartridge.
Note: If you replaced a cartridge while copying a document or photo, cancel
printing and make sure your original is still placed correctly on the document table.
Then copy your original again.
Art837QG.book Page 28 Wednesday, April 27, 2011 4:07 PM