Elmo Document Camera P30S - Manual (Page 7)

86
ENGLISH
Be sure to use the power cord and AC adapter attached to this camera system as
accessories.
The power cord applicable to the local power specifications is attached. Be sure
to use the power cord applicable to your local power specification.
Do not leave this product under direct sunlight or by heaters, or this product may
be discolored, deformed, or damaged.
Do not place this product in any humid, dusty, windy or vibrating location. Use this
product in the following environmental conditions:
Temperature: 0 ° C~40 ° C (32 ° F~104 ° F)
Humidity: 30%~85% (No condensation)
In handling (including setting up and storing) or carrying the camera, be
meticulously careful not to give an impact on the camera head.
To prevent dropping and falling, observe the following:
• Use the camera on a stable stand, desk or table. Never put the camera on
any shaky stand or inclined or instable place.
• Before using, lay out the power cord, the AC adapter cable and the video
cable not to be pulled, and wire them accordingly.
Do not move the camera column or the lamp column while your finger is being
placed between the camera column and the lamp column. Otherwise, your finger
may be pinched and injured.
Use a soft, dry cloth for cleaning. Do not use any volatile solvent, such as thinner
or benzine.
Do not directly point the camera lens into the sun, or the camera may be
damaged.
Caring for the batteries:
• If this camera system is not used for a long time, take out the batteries from
the wireless remote control.
• Do not use rechargeable batteries (e.g., Ni-Cd).
• Do not use new and old batteries, or batteries of different types together.
• Do not try to recharge or short-circuit the batteries.
• When disposing of used batteries, follow the instructions from each local
government.
Luminescent and Black Spots
This camera has a CMOS area image sensor and a color LC panel, which are
composed of many pixels. Some of these pixels may not operate normally. As a
result, a luminescent spot or a black spot may appear on the output screen.
However, this is a phenomenon unique to the CMOS area image sensor and color
LC panel and therefore this phenomenon is not faulty.
Do not press the LC panel strongly or with a sharp-pointed object, or it would
cause break or failure to the color LC panel.
BEFORE YOU USE
書画カメラ P30S.book 86 ページ ２００８年１月２４日 木曜日 午後６時３８分