Wolf 30 Inch Built-in Gas Grill Installation Guide - Manual (Page 5)

wolfappliance.com | 5
Installation Requirements
For portable applications, Wolf grill carts are designed
specifically to fit grill models OG30, OG36 and OG42 and
the side burner. Model OG54 is designed for built-in appli-
cations only.
For built-in applications, Wolf outdoor grills and the burner
module are designed for easy placement into a built-in
enclosure. For outdoor grills, installation in a combustible
enclosure requires an insulating liner. For the burner module,
an insulating liner is not required. The enclosure should be
built according to specifications for your specific installa-
tion on the following pages. If the burner module is installed
next to an outdoor grill, a minimum of 12"
(305) is required
between units on the rotisserie motor side and 2" (51) on the
opposite side. A rotisserie side conversion kit is available
from an authorized Wolf dealer.
Grill carts, insulating liners and stainless steel doors and
drawers are avail able through an authorized Wolf dealer. For
local dealer information, visit the find a showroom section of
our website, wolfappliance.com.
SPECIFICATIONS
Electrical
Installation must comply with all applicable electrical codes.
The electrical outlet must be located within reach of the
power cord. A separate circuit, servicing only this appliance
is required.
IMPORTANT NOTE: A ground fault circuit interrupter (GFCI)
is required to reduce the risk of electrical shock.
ELECTRICAL REQUIREMENTS
Electrical Supply grounded, 120 VAC, 60 Hz
Service 15 amp dedicated circuit
Receptacle 3-prong grounding-type, GFCI
Power Cord 6' (1.8 m) , 9' (2.7 m) rotisserie