beautypg.com

Error codes – LG TurboSteam Series 27 Inch Electric Dryer User Manual and Installation Guide User Manual

Page 30

background image

30

INSTALLATION

Check the Duct Condition

If the Flow Sense™ LED is turned on, check the

exhaust system for restrictions and damage. Repair

or replace the exhaust system as needed.

NOTE

• When the dryer is first installed, this test should be

performed to alert you to any existing problems with

the exhaust duct in your home. However, since the

test performed during normal operation provides

more accurate information on the condition of the

exhaust duct than the installation test, the number

of bars displayed during the two tests may not be

the same.

• Do not interrupt the test cycle, as this could result in

inaccurate results.

• Even if no bars are displayed during the test cycle,

some restrictions may still be present in the exhaust

system. Refer to the Venting the Dryer section

of this manual for complete exhaust system and

venting requirements.

• Your dryer features Flow Sense™, an innovative

sensing system that automatically detects

blockages and restrictions in the dryer ductwork.

Keeping ductwork clean of lint buildup and free of

restrictions allows clothes to dry faster and reduces

energy use.

Error Codes

Check the error code before you call for service.

Error

Code

Possible

Causes

Solutions

tE1 or

tE2

Temperature

sensor failure.

Turn off the dryer and call

for service.

HS

Humidity sensor

failure.

Turn off the dryer and call

for service.

PS,

PF, or

nP

Electric dryer

power cord is

not connected

correctly, or

house power

supply is

incorrect.

Check the power supply

or the connection of

the power cord to the

terminal block. Refer to

the Connecting Electric

Dryers section of this

manual for complete

instructions.

House fuse is

blown, circuit

breaker has

tripped, or

power outage

has occurred.

Reset circuit breaker

or replace fuse. Do

not increase the fuse

capacity.

If the problem is a

circuit overload, have it

corrected by a qualified

electrician.

gAS

Gas supply or

service turned

off. (Gas Model

only.)

Confirm that house gas

shutoff and the dryer

gas shutoff are both fully

open.