DCS Use & Care Guide - Manual (Page 23)

21
NOTE:
If any of the listed items are missing, contact DCS at (888) 936-7872. Please be prepared with your
Model #, Serial # and description of item(s) that are missing.
Read all installation instructions in this manual to see if the unit has been properly installed. If not done or
done correctly, correct before using the unit.
o Specified clearances main-
tained to combustibles.
o Verified proper enclosure
ventilation.
o All internal packaging and
any adhesive residue
removed. To remove stub-
born residue, use rubbing
alcohol or a commercially
available adhesive remov-
er.
o Removed shipping brack-
ets
o Knobs turn freely, bezels
centered.
o Each burner lights satis-
factorily, individually or
with adjacent burner lit.
o Air shutters adjusted.
o Low flame setting satis-
factory.
o Drip pan in place properly
and sliding freely.
o Pressure regulator con-
nected and set for 4.0”
W.C. Natural, 11.0” W.C. LP
gas.
o Manual shut-off valve
installed and accessible.
o Unit tested and free of
leaks.
o User informed of gas
supply shut-off valve
location.
o All radiants are assembled
and put in place.
o Check match lighting.
n
PLEASE LEAVE THESE
INSTRUCTIONS WITH THE
USER.
n
USER, PLEASE RETAIN
THESE INSTRUCTIONS
FOR FUTURE REFERENCE.
INSTALLATION
INSTALLER CHECKLIST
Tag location of
Model # and Serial #