DCS Use & Care Guide - Manual (Page 15)

13
FIG. 06
Access Doors -
Cutout dimensions
A
90º
B
Vent*
Vent*
Vent*
MODEL NUMBER A B
(+0,-1/8) (+1/8,-0)
ADN1- 20x48 46” 20”
ADN1- 20x36 34” 20”
ADN1- 20x30 28” 20”
ADN1- 20x24 22” 20”
Cutout for Access Doors
Access Drawers
Cutout dimensions
NOTE: The cutout of each corner should be 90 º angle in order for the access
drawers to fit properly.
* Island installation to use minimum of 3 vents, 10 square inches / 64,5cm 2 per
vent (typical).
** For proper support and drawer operation, insure that support boards are
installed per Installation Guide instructions.
To order access drawers or doors, please call DCS Customer Care at 1.888.936.7872 for DCS Dealer in your area.
MODEL NUMBER A B C
(+0,-1/8) (+1/8,-0)
ADR2-48 46” 20”
ADR2-36 34” 20”
ADR2-30 28” 20”
ADR2-24 22” 20”
24-1/2”
(Min,
All
Models)
NOTE: The cutout of each corner should be 90 º angle in order
for the access doors to fit properly.
* Island installation to use minimum of 3 vents, 10 square
inches / 64,5cm 2 per vent (typical).
FIG. 07
INSTALLATION
BUILT–IN CONSTRUCTION DETAILS