Hestan 30 Inch Drawer Microwave Use and Care Manual - Manual (Page 24)

OTHER FEATURES
(CONT.)
END OF COOKING REMINDER
At end of timed cooking, the microwave will signal every 10 seconds for the first minute; then every 3
minutes until
STOP/CLEAR
pad is touched, up to one hour.
TO TURN REMINDER OFF
1. Touch SETUP/HELP pad three times. The display shows
REMIND SIGNAL OFF ? TOUCH START
.
2. Touch
START/ add minute pad. The display shows
REMIND SIGNAL OFF
.
TO TURN REMINDER SIGNAL BACK ON
3. Touch
SETUP/HELP
pad three times. The display shows
REMIND SIGNAL ON ? TOUCH START
.
4. Touch
START/ add minute pad. The display shows
REMIND SIGNAL ON
.
TIMED START
If you wish to program the Drawer Microwave to begin cooking automatically at a designated time of
day, follow this procedure.
1. Touch
SETUP/HELP
pad 4 times. The display shows
AUTO START TOUCH START .
2. Touch
START/ add minute pad.
ENTER START TIME
3. Enter start time.
4:30 TOUCH CLOCK
4. Touch
TIMER/CLOCK
pad.
ENTER COOKING TIME
5. Touch the number pads to enter cooking time.
20.00 TOUCH START OR TOUCH POWER
LEVEL
Touch
POWER LEVEL
pad repeatedly until the desired power level is reached.
TOUCH START
6. Touch
START/ add minute pad.
DEMONSTRATION MODE
The Drawer Microwave doesn’t heat in Demo Mode, and the display counts down quickly.
TO SELECT DEMO MODE
1. Touch SETUP/HELP pad five times. The display shows
DEMO ON? HOLD START 3 SEC
.
2. Hold START/ add minute pad for 3 seconds. The display shows
DEMO ON
.
TO CANCEL DEMO MODE
1. Touch SETUP/HELP pad five times. The display shows
DEMO OFF ? TOUCH START
.
2. Touch START/ add minute pad. The display shows
DEMO OFF
.
NOTE:
• If the electrical power supply to your Drawer Microwave should be interrupted, the display will
intermittently show
ENJOY YOUR MICRO- WAVE TOUCH CLEAR AND TOUCH CLOCK
after
the power is reinstated. If this occurs, any SETUP/HELP options you input will be erased. Simply
touch
STOP/CLEAR
and set the clock.
STANDBY MODE
This microwave will go into standby mode after a period of inactivity. The backlight of the display
will automatically dim after 3 minutes if the unit has not been in operation. If the display is in standby
mode, simply touch the control panel or open/close the door to return the backlight to maximum
brightness.
©2019 Hestan Commercial Corporation
22
EN