Before operating, Before operating introduction – Hestan 30 Inch Drawer Microwave Use and Care Manual User Manual
Page 14

WARM
KEEP
WARM
CONTROLS
The following illustration depicts the control panel and shows the page numbers to find
information about each item.
Numbers next to the illustration indicate pages on which
there are feature descriptions and usage information.
14
18
21
16
13
21
18
13
19
21
13
12
20
19
15
14
BEFORE OPERATING
INTRODUCTION
(CONT.)
Before operating your new Drawer Microwave make sure you read and understand this operation
manual completely.
• Before the Drawer Microwave can be used, follow these steps:
1. Plug in the Drawer Microwave.
ENJOY
YOUR
MICRO-
WAVE
TOUCH
CLEAR
AND
TOUCH
CLOCK
will appear.
2. Touch the
STOP/CLEAR
pad.
:
will appear.
3. Set clock as follows:
TO SET THE CLOCK
4. Touch
TIMER/CLOCK
pad and number
2
.
5. Touch number pads for correct time of day and touch
TIMER/CLOCK
pad again.
This is a 12 hour clock. If you attempt to enter an incorrect clock time,
ERROR
will appear in the
display. Touch the
STOP/CLEAR
pad and re-enter the time.
• If the electrical power supply to your Drawer Microwave should be interrupted, the display will
intermittently show
ENJOY
YOUR
MICRO-
WAVE
TOUCH
CLEAR
AND
TOUCH
CLOCK
after the power is reinstated. If this occurs during cooking, the program will be erased. The
time of day will also be erased. Simply touch
STOP/CLEAR
pad and reset the clock for the
correct time of day.
NOTE:
• The Drawer Microwave can be programmed with the drawer open except for
START
/
add
minute
.
TIMER
1. Touch
TIMER/CLOCK
pad and number
1
.
2. Enter time.
3. Touch
TIMER/CLOCK
pad again.
To cancel timer, touch
STOP/CLEAR
.
©2019 Hestan Commercial Corporation
12
EN