Extron electronic IPI 100 Series - Manual (Page 7)

IPI 100 Series, IPI 200 Series • Quick Start Guide QS-3
Quick Start Guide — IPI 201, IPI 204
W Installation and service must be performed by authorized
personnel only. These products must be used with UL
approved, grounded electrical boxes.
To install an Extron IP Intercom ® System, follow the steps below:
Step 1
Turn all of the equipment off and disconnect the power cords.
Step 2
Select the installation location and install an electrical wall box for
each IPI 201 or IPI 204 unit in the system. See “Sample Applications”
on page 2-8 for ideas on designing an intercom system.
Step 3
Install button labels in each of the IPI’s buttons. See page 2-2 for
instructions.
Step 4
Mount each IPI into an AAP wallplate, mounting bracket for 2-gang
wallplates or device faceplate, as described on page 2-4.
Step 5
Cable each IPI to other devices: connect the IPI’s LAN port to the
local network via a standard network cable with RJ-45 connector,
and, if desired, cable the rear panel Audio connector (see page 2-8) to
speakers for local audio output.
Step 6
Install each IPI into the wallboxes you installed in step 2 above.
Step 7
Connect the console PC(s) to the network.
Step 8
Connect the PC(s) and IPI(s) to power sources and turn on the PC(s).
Step 10
Install the Extron IP Intercom HelpDesk software on a PC. See page
4-2 for software installation instructions.
Step 11
Use the IP Intercom HelpDesk software and Configuration Utility
to configure all IPI units that are part of the system. See “Setup
procedure” on page 4-20 for instructions on configuring the IPIs.