Extron electronic IPI 100 Series - Manual (Page 65)

IPI 100 Series, IPI 200 Series • Programming and Control 5-7
X1$
= IP address (xxx.xxx.xxx.xxx). Leading zeros in each of four fields are
optional in setting values, and they are suppressed in returned
values.
IPI’s default address: 192.168.254.254
Default broadcast address: 255.255.255.255.
X1%
= E-mail domain name; for example, extron.com
X1*
= Hardware (MAC) address (xx-xx-xx-xx-xx-xx) (00-05-A6-xx-xx-xx)
X1(
= Subnet mask (xxx.xxx.xxx.xxx). Leading zeros are optional in setting
values in each of four fields, and they are suppressed in returned
values. Default = 255.255.0.0.
X2@
= Verbose/response mode status:
0 = clear/none, default for Telnet connections; responses are not
echoed to the host
1 = verbose mode is on, default for RS-232 host control; responses
are echoed to the host and displayed to the user
2 = send tagged responses for queries
3 = verbose mode is on and tagged responses are sent for queries
N If tagged responses are enabled, all read commands return
the constant string + data, the same as for setting a value.
For example, for
E
CN
}
, the response is Ipn•
X1@ ]
rather than just the data.
X3#
= Password (minimum length = 4 characters, maximum length = 12
characters, no special characters are allowed)
N A user password cannot be assigned if no administrator
password exists; the E14 error code will be returned. If the
administrator password is cleared, then the user password is
also removed.
X3$
= Daylight saving time (DST) is a region-specific 1-hour offset that
begins in spring and ends in fall.
0 = off/ignore
1 = USA on – traditionally starts on the first Sunday of April
at 2 am and ends at 2 am on the last Sunday of October. For
example, time in California is GMT -8:00 from April to October
and GMT -7:00 from November to March. However, in 2007 DST
starts on the second Sunday in March and ends the first Sunday
in November. DST should be turned off in Hawaii, American
Samoa, Guam, Puerto Rico, the Virgin Islands, the eastern time
zone portion of the state of Indiana, and the state of Arizona
(excluding the Navajo Nation).
2 = Europe on – begins on the last Sunday in March, ends on the
last Sunday in October. DST should be turned off for Iceland.
X3%
= Event number, range = 0 - 99
(valid only while events are running)
X4!
= Password to display on screen (response to password query or set).
When the MLC connects to a host device via RS-232, the password
(
X3#
), itself, is the response. When the connection is via IP,
X4!
is
4 asterisks (****) if a password has been assigned, or it is an empty
field ( ) if a password hasn’t been assigned.
X4%
= E-mail event number or mailbox (1 - 64). The response is two digits
with a leading zero.