Extron electronic IPI 100 Series - Manual (Page 17)

IPI 100 Series, IPI 200 Series • Installation 2-3
2. Locate the small corner notch on the lens cap and slide
the screwdriver between the lens cap and the diffuser, as
shown in
Ç
.
Using a rotating motion of the screwdriver (see
É
),
carefully pry the two pieces apart.
3. Replace the label with the new button label.
4. Press the lens cap and diffuser together and reinstall the
button assembly into its plunger/base.
5. Repeat steps 1 through 4 for each button you plan to re-
label.
TEXT
Separating the two-
piece button here at
the corner.
Pry the two
pieces apart.
Diffuser
Plunger
Base
Button Label
Clear Lens
Notch
З
Й