Enterasys Networks FN 100 - Manual (Page 44)

Using FN100 Trunking
4-2 The Port Trunking Window
To display the Port Trunking window from the FN100 Chassis View:
1. Click to display the Device menu.
2. Drag down to Port Trunking..., and release. The Port Trunking window,
Figure 4-1 , will appear.
Figure 4-1. The Port Trunking Window
The Port Trunking Window
The Port Trunking window features the trunking table (in the upper portion of
the window), which displays the following information about each interface for
which trunking is enabled:
Index
Displays the port’s sftrunkIfIndex identifier.
State
Indicates the port’s trunking condition (sftrunkState). The possible states are:
• closed — trunking is enabled, and the trunking protocol is attempting to
establish a trunk connection, but the port has not yet received any trunking
PDUs.
• oneway — trunking is enabled, and the trunking protocol is attempting to
establish a trunk connection, but incoming trunking PDUs do not indicate that