Enterasys Networks FN 100 User Manual
Page 19
Viewing Chassis Information
2-3
The FN100 Chassis View
•
Green
indicates the FN100 is responding to device polls (valid connection).
•
Magenta
indicates that the FN100 is in a temporary stand-by mode while it
responds to a physical change in the hub; note that port menus are inactive
during this stand-by state.
•
Blue
indicates an unknown contact status – polling has not yet been
established with the FN100.
•
Red
indicates the FN100 is not responding to device polls (device is off line, or
device polling has failed across the network for some other reason).
UpTime
The amount of time, in a day(s) hh:mm:ss format, that the FN100 has been
running since the last start-up.
Port Status
If management for your device supports a variable port display (detailed in
, later in this chapter), this field will show the display
currently in effect. If only a single port display is available — or if the default view
is in effect — this field will state Default.
MAC
The physical layer address assigned to the interface associated with the IP
Address used to define the device icon when it was added to NetSight Element
Manager. MAC addresses are factory-set cannot be altered.
Boot Prom
The revision of BOOT PROM installed in the FN100.
Firmware
The revision of device firmware stored in the FN100’s FLASH PROMs.
Time
The current time, in a 24-hour hh:mm:ss format, set in the FN100’s internal clock.
Date
The current date, in an mm/dd/yy format, set in the FN100’s internal clock.
NOTE
Boot Prom, Firmware, Time, and Date, are not available for the FN100 at the time of this
release.