Elation Professional Design Spot 250 Pro - Manual (Page 30)

Design Spot 250 Pro™
©Elation Professional® 30 Design Spot 250 Pro™
“Quick” is the default setting.
8.4.3 Fans Control - This function is used to change the functionality of the internal
cooling fans. The available selections are: 1) “AUTO” – The fans will automatically
switch between low and high speeds depending on the internal operating temperature. 2)
“HIGH” – The fans will run in high-speed mode regardless of operating temperature. 3)
“LOW” – The fans will remain in low speeds regardless of internal operating
temperature.
8.4.4 Display Settings – The display is designed to turn off during normal operation to
avoid excessive light in situations that require an extremely dark environment. This
function will adjust the time delay the fixture will before it turns off. This function is
disabled as default.
8.4.5 Temperature C/F – This function changes the temperature the unit will display
from either Celsius or Fahrenheit. Celsius is set as default.
8.4.6 Initial effect – This function allows a user to create and assign a custom “Home
Position” into the fixture. Adjusting the Pan and Tilt values then locking those values into
the fixture’s internal memory creates the new “Home” position.
8.4.7 Reset Default – This function is used to restore the fixture’s original factory
settings. All settings will be set back to the default values (shaded). Any edited scenes
will be lost.
8.5 Reset Functions: The reset function returns a motor to the “Home” position. There are
several reset functions available on this fixture. The list below details the functionality of
each available selection.
8.5.1 Reset All: This function will reset all internal motors to the home position.
8.5.2 Reset Pan and Tilt: This function will only reset the pan and tilt motors to the
home position.