Elation Professional Design Spot 250 Pro - Manual (Page 24)

Design Spot 250 Pro™
©Elation Professional® 24 Design Spot 250 Pro™
8.1.2 “Value Display” - Display the DMX 512 value of each channel
With this function you can display the DMX 512 value of each channel. The display will
automatically detail the changing DMX values as they are received from the controller.
8.1.3 “Set to Slave” - Slave setting for Master/Slave Operation
With this function, you can define the device as slave for operation in Master/Slave
mode. Each slave setting will have a different function for a dynamic lightshow without a
controller.
8.1.4 Auto Program
This function allows the internal programs to run in either stand-alone or master/salve
mode. In “Master” mode the fixture will send DMX data to other fixtures connect via the
DMX chain. In “Alone” mode the fixture will operate as a single fixture. The program for
this mode is selected in the “Select program” section of the control menu. You can set
the number of steps under “Edit program”. You can edit the individual scenes under
“Edit scenes”. With this function, you can run the individual scenes either automatically,
i.e. with the adjusted Step-Time.
8.1.5 Music control
This function is similar to the “Auto Program” described in the previous section with the
exception that this function will advance the built-in program via sound.
8.2 Information:
8.2.1 Time information
These functions will detail different time functions associated with the fixture.
Current Time
This function displays the running time of the fixture from the last power on. The
display shows “XXXX”, where “XXXX” represents the number of hours the fixture
has been running. This counter is automatically reset after every power-on.
Total Run Time
This function tracks the total running time of the fixture from the very first start-up.