Eclipse - Fujitsu Ten CD3434 - Manual (Page 81)

81
Mounting instruction
Names of lead wires and destinations (refer to Page 82)
No. Name Wire color Destination
1 ACC Red Connect where the power comes on
when the ignition is in the ACC
position.
2 B+ Yellow Connect where the power is constantly
available, regardless of the ignition
switch's position.
3 Ground Black Connect where good body grounding
is available.
4 Antenna power supply Blue Connect to the automatic-antenna
control terminal of the vehicle.
5 Illumination power supply Orange/White Connect to where power comes on
when the headlights are turned on.
6 Control power supply Blue/White Connect to the control terminal for
the external amplifier, etc.
7 E-LAN terminal Connect to the E-LAN terminal of the
CD changer, DSP, etc.
8 & 9 Line-out terminals Connect to the RCA input connectors
of an external amplifier,or to the RCA
input connectors of a DSP or EQ.
10 Line-out terminals (Nonfader) Connect to the RCA input connectors
of a DSP or EQ, or the RCA connectors
of a woofer amplifier.
11 Speaker leads Connect them to their respective
speaker leads.
12 Cellular phone mute Pink Connect to the ground output terminal
on a mobile phone.
Note
To prevent unconnected leads from shorting out, insulate them
by wrapping their tips with electrical tape. Similarly, insulate the
ends of connected leads.
If an external amplifier is to be connected to the receiver, be
sure to ground its outside housing to the vehicle body (a metal
part).
Caution
Never connect the power supply to the speaker leads,
otherwise it cause damage to the main unit.