Eclipse - Fujitsu Ten CD3434 - Manual (Page 36)

36
Basic operation
Here, the LPF (low-pass filter) to the non-fader pre-out can be
switched ON and OFF.
Since the low-pass filter passes only lower ranges (higher
ranges are cut off), efficient playback is enabled by cutting off
mid to higher range elements not needed for a woofer.
Turn [SEL] button to select X-OVER NF.
Press the [SEL] button.
The cross over (non-fader) switching mode is activated.
Turn [SEL] button to select ON or OFF.
Press the [RTN] button.
At this time, other adjustments can also be made in sound
adjustment mode.
Press the [SOUND] or [RTN] button to exit sound
adjustment mode.
5
4
3
2
1
Sound integration can be improved for full range speakers and
woofers by switching the phase.
Switch the phase and select an integration method that is
compatible.
Turn [SEL] button to select Non-FADER.
Press the [SEL] button.
The non-fader setting mode is activated.
Turn [SEL] button to select NORMAL or REVERSE.
Press the [RTN] button.
At this time, other adjustments can also be made in sound
adjustment mode.
Press the [SOUND] or [RTN] button to exit sound
adjustment mode.
5
4
3
2
1
Disabling the Cross Over (NF) function
Switching Non-Fader modes
[SOUND] button
[SEL]
button
[RTN] button