Eclipse - Fujitsu Ten CD3434 - Manual (Page 53)

53
How to operate the tuner
Preset station scan
Press the [SEL] button for less than one second. 1
[P SCAN] will appear at the display, and stations stored under
preset buttons [1] through [6] will be played for five seconds
each.
To stop the preset scan mode at a desired station, press
the [SEL] button again.
2
The receiver will stay tuned to the desired station.
Check that the deck is in standby mode. 1
Press and hold the button [1], then [FM AM] button, and
hold both for more than three seconds. 2
The mode switches between AUTO mode and DX mode each
time the buttons are pressed.
This function enables reception of all the stations in the preset
buttons for five seconds each.
Changing the reception sensitivity for automatic scanning
The deck lets you select the reception sensitivity to be used for
automatic scanning of stations. The two sensitivity modes available
for this deck are AUTO mode and DX mode.
AUTO mode
During automatic scanning, the reception sensitivity
switches automatically to one of two levels. Initially the
reception sensitivity is set to the low level so that only
stations with strong signals are received. If no stations
could be received, the reception sensitivity is increased
so that stations with weaker signals can also be
received.
DX mode
Because the reception sensitivity for automatic scanning
is set to the high level from the start, even stations with
weaker signals can be received. (Signal crossover may
result in some stations being hard to hear.)
[FM AM] button
Buttons [1] to [6]
[SEL]
button