Eagle Electronics FishElite - Manual (Page 149)

141
• GGA transmits time, position, and fix related data.
• GSA and GSV transmits fix mode, DOP values, and satellites in
view information.
• DBT transmits the depth below the transducer.
• DPT transmits the depth
• MTW transmits the water temperature.
• VLW transmits the distance traveled through water as meas-
ured by the paddle wheel.
• VHW transmits the water speed as measured by the paddle
wheel.
4. Press ENT , then use
↑ ↓ → ← to enter the station frequency, then
press ENT .
5. Press
→ to
B
IT
R
ATE
| ENT then use
↑ ↓ to select the station bit rate,
then press ENT .
6. A. If you are
not using a Starlink DGPS receiver, press
EXIT | EXIT | EXIT | EXIT to return to the previous page.
B. If you
are using a Starlink DGPS receiver, press ↓ to
S
TARLINK
A
UTO
T UNING M ODE
|press ENT |press EXIT | EXIT | EXIT | EXIT to return to the pre-
vious page.
Configure NMEA
You can configure the unit to use specific NMEA sentences.
1. Press MENU | MENU |
↓ to
S YSTEM S ETUP
| ENT .
2. Press
↓ to
C OMMUNICATIONS P ORT
| ENT |
↓ to
C ONFIGURE NMEA | ENT .
3. A menu appears showing the prefixes of the available NMEA sen-
tences. A check mark next to a prefix means the prefix is in use. Use
↑
↓ → ← to select a prefix, then press
ENT to turn off the prefix. (Press
ENT again to check the box and turn a prefix on.)
4. When the desired prefixes are checked or unchecked, press
EXIT | EXIT | EXIT | EXIT to return to the previous page.
Coordinate System Selection
The Coordinate System Menu lets you select the coordinate system to
use when displaying and entering position coordinates.