Tascam BD-MP4K Professional-Grade 4K UHD Blu-ray Player - Manual (Page 43)

TASCAM BD-MP4K
43
Network connection overview
From the Home Screen, use Settings > General Settings >
Network to set the network connection.
1. In the submenu, set “ Internet Connection ” to “ Enable ”.
Use the ; cursor or ENTER button to move to the function
setting. Use the j and k cursor buttons to select “ Enable ”
or “ Disable ” and press the ENTER button to confirm.
To exit a submenu, press the l cursor button repeatedly to
return to the first screen.
2. Set the method of Internet access for the unit to “ Ethernet ”
or “ Wireless ”* in the “ Interface ” submenu.
* “Wireless” connection can only be used if a USB-wireless LAN
adapter has been connected to the unit.
( A USB-wireless LAN adapter is not included with this unit.
Prepare one for use as necessary. For recommended wireless
LAN adapters, see the TASCAM website ( https://tascam.
com/us/ ).)
Use the ; cursor or ENTER button to move to the function
setting. Use the j and k cursor buttons to select
“ Ethernet ” or “ Wireless ” and press the ENTER button to
confirm.
The following message will appear when the current setting
is changed.
To continue , select “ Yes ” and press the ENTER button.
o Using a wireless connection
The following connection methods can be selected.
i Scan
The unit will search for access points, allowing selection
of a network.
i Manual
An SSID can be set manually to connect.
i Auto
Connection is possible using Wi-Fi Protected Setup
(WPS) standards.
3. To use IPv6, set “ IPv6 On ” in the submenu to “ Enable ”.
When enabled, “ IP Protocol Priority ” sets whether to
prioritize IPv4 or IPv6.
4. From the “ IPv4 Information ” submenu, network
information can be checked on the following screen.
Press the RETURN button to return to the previous screen.
o Information shown
Interface, address type, IP address, subnet mask, default
gateway, DNS1 and DNS 2.
5. When “ IPv6 On ” is set to “ Enable ”, “ IPv6 Information ” can
be checked on the following screen.
Press the RETURN button to return to the previous screen.
o Information shown
Interface, Link-Local Address, IP address, Prefix, gateway,
DNS1 and DNS 2
6. The network can be tested with “ Connection Test ” in the
submenu.
The following messages appear if there is a problem with
the network connection.
i “ Network FAILED " Problem with network
i " Proxy FAILED " Problem with proxy
7. Select how the unit's IPv4 address is set in the “ IPv4
Setting ” submenu.