Marantz AV 10 Reference 15.4-Channel Home Theater Preamplifier/Processor - Manual (Page 139)

Direct playback
Sound recorded in source is played as is.
1
Press PURE to select “Direct”.
Direct playback begins.
0
While DSD signals are played back, “DSD Direct” is displayed.
0
This can also be set by pressing PURE DIRECT on the main unit.
Pure Direct playback
This mode is for playback with higher sound quality than in Direct playback
mode.
This mode turns off the main unit display. Doing so suppresses noise
sources that affect sound quality.
1
Press PURE to select “Pure Direct”.
The display goes dark, and Pure Direct playback begins.
0
In Direct and Pure Direct sound modes, the following items cannot be adjusted.
0
Dialog Enhancer ( v p. 129)
0
Tone ( v p. 131)
0
M-DAX ( v p. 181)
0 MultEQ ® XT32 ( v p. 183)
0
Dynamic EQ ( v p. 184)
0
Dynamic Volume ( v p. 185)
0
Graphic EQ ( v p. 186)
0 This can also be set by pressing PURE DIRECT on the main unit.
NOTE
0
When the Pure Direct mode has been selected, the display turns off after about 5
seconds.
Contents Connections Playback Settings Tips Appendix
139
Front panel Display Rear panel Remote Index