Quantum Instruments Qflash TRIO Basic Flash for Cameras User Manual
Page 27
12. AF Auto Fill Mode Operation
12.1 On camera Auto Fill mode
F/number, ISO are sent to the
flash from the camera. Only
the Fill flash setting is user
adjustable. Press the
Set
button to highlight the Fill
setting. Use the
left
(-)
Å
and
right
(+)
Æ
arrow buttons to
adjust the Fill down or up.
The Fill setting is used to adjust the flash output from 3 stops (-3) below
the camera setting to 2 stops (+2) above the camera setting. The Fill
can be adjusted in 1/3 steps.
Flash distance displays the working distance between your Qflash and
Subject based on the current settings. Moving outside this range may
result in an Under or Overexposed picture.
Using the Radio
The internal radio can be used to trigger remote flashes, or room lights,
set radio to
SYNC
.
Or the radio can be used to control the light output of remote Qflashes,
set radio to LINK. The remote flash can be another Trio in
RL
mode or a
Qflash model 5d-R set to
Linked to Local
with an FW7Q, FW8R, or
FW10w.
Be sure that the channel and zones match the Channel and Zones set
on the Trio. See section 8.0 for setting the channel and zones on the Trio
12.2 Auto Fill mode soft keys
See section 11.3
12.3 Auto Fill mode exposure indications
See section 11.4
12.4 Auto Fill Sensor Limit
See section 11.5
12.5 Using the Sensor Limit
See section 11.6
25
MODE
/OK
SET
A
UTO FILL +0
F
5.6
7
3.6 –32 FT
ISO
200
FIRE OPT SAVE RADIO
+
-
AF