HP Z31x 31.1" 17:9 DreamColor Studio Cinema 4K IPS Display - Manual (Page 17)

4. To attach the monitor head to a swing arm or other mounting device, insert four mounting screws
through the holes on the mounting device and into the VESA screw holes on the back of the monitor
head.
IMPORTANT: If these instructions do not apply to your device, then follow the mounting device
manufacturer’s instructions when mounting the monitor to a wall or swing arm.
Connecting the cables
In addition to details about how to connect a cable, this section contains information about how your monitor
functions when you connect certain cables.
NOTE: This monitor supports DisplayPort, HDMI, or USB Type-C inputs. The video mode is determined by the
video cable used. The monitor automatically determines which inputs have valid video signals. You can select
the inputs through the OSD menu. The monitor ships with select cables. Not all cables shown in this section
are included with the monitor.
1. Place the monitor in a convenient, well-ventilated location near the computer.
2. Route the signal cable and power cable through the cable routing fixture on the monitor stand.
3. Connect a video cable.
● Connect one end of a DisplayPort cable to the DisplayPort connector on the rear of the monitor and
the other end to the DisplayPort connector on the source device.
Setting up the monitor 9