Mounting the monitor head, Removing the monitor stand, Attaching the vesa mounting bracket – HP OMEN 27" HDR 165 Hz Gaming Monitor User Manual
Page 12: 6 attaching the vesa mounting bracket

Mounting the monitor head
The monitor head can be attached to a swing arm or the stand.
IMPORTANT:
This monitor supports the VESA® industry-standard 100 mm mounting holes. To attach a
third-party mounting solution to the monitor head, use four 4 mm, 0.7 pitch, and 10 mm long screws. Longer
screws might damage the monitor. Be sure that the manufacturer’s mounting solution is compliant with the
VESA standard and is rated to support the weight of the monitor head. For best performance, use the power
and video cables provided with the monitor.
NOTE:
This apparatus is intended to be supported by a UL-listed or CSA-listed wall-mount bracket.
Removing the monitor stand
You can remove the monitor head from the stand to install the monitor head on a swing arm or other
mounting fixture.
IMPORTANT:
Before beginning to disassemble the monitor, be sure that the monitor is turned off and all
cables are disconnected.
1.
Disconnect and remove all cables from the monitor.
2.
Position the monitor facedown on a flat surface covered by a clean, dry cloth.
3.
Tilt the bottom of the monitor stand upward (1), use the allen tool to loosen the two screws on the
underside of the monitor's hinge (2), and then slide the stand off the monitor head (3).
Attaching the VESA mounting bracket
This display is compatible with most VESA mounting arms and mounts (sold separately). The VESA mount
should support a 100 x 100x mm VESA mounting standard and should be able to rotate at least 45°.
1. NOTE:
The swing arm for this monitor must include a VESA mounting adapter with a rotation function
to accommodate the landscape design of the monitor.
1.
Remove the monitor stand if it is attached. See
Removing the monitor stand on page 6
6
Chapter 2 Setting up the monitor