Extron Electronics RGB 201 - Manual (Page 40)

RGB 201 Rxi Universal Interface • Reference Information
Reference Information, cont’d Reference Information
A-2
Specifications
Video
Gain .................................................. 0.5V to 1.45V p-p
Bandwidth ....................................... 300 MHz (-3dB)
Rise time ........................................... 1.5 ns
Video input
Number/signal type ....................... 1 analog RGBHV, RGBS, RGsB, RsGsBs
Connectors ...................................... 1 female 15-pin HD
Nominal level .................................. 0.7 Vp-p for RGB
Minimum/maximum levels .......... Analog: 0.3 V to 1.45 Vp-p with no offset at
unity gain
Impedance ....................................... 75 ohms
Horizontal frequency...................... 15 kHz to 150 kHz
Vertical frequency ........................... 40 Hz to 140 Hz
Return loss ...................................... <-30dB @ 5 MHz
Maximum DC offset ...................... 4 V
Video output
Number/signal type ....................... 1 analog RGBHV, RGBS, RGsB
Connectors ...................................... 6 BNC female
Nominal level .................................. 0.7 Vp-p for RGB
Minimum/maximum levels ......... 0.3 V to 1.30 Vp-p with 0.7 Vp-p nominal
input level
Impedance ....................................... 75 ohms
Return loss ...................................... -30 dB @ 5 MHz
DC offset .......................................... ±5 mV with input at 0 offset
Sync
Input type ........................................ RGBHV, RGBS, RGsB, RsGsBs
Output type ...................................... RGBHV, RGBS, RGsB
Input level ....................................... 2 V to 5.5 Vp-p with ±0.2 VDC offset max.
Output level ..................................... TTL: 4V to 5 Vp-p, unterminated
Input impedance ............................ 510 ohms
Output impedance ......................... 75 ohms
Max. propagation delay ................. 85 ns
Max. rise/fall time .......................... 2 ns
Polarity .............................................
RGBHV: tracks polarity (or force negative
sync via internal jumper)
RGBS, RGsB: negative