Extron Electronics RGB 201 - Manual (Page 19)

RGB 201 Rxi Universal Interface • Installation and Operation 2-7
4 . Insert the four wood screws into the pilot holes. Fasten
each screw into the installation surface until just less than
1/4" of the screw protrudes.
5 . Align the installed screws with the slots in the mounting
brackets, and place the interface against the surface, with
the screws through the bracket slots.
6 . Slide the interface slightly forward or back, then tighten all
four screws to fasten it in place.
Through-desk mounting
1 . If rubber feet were installed on the interface, remove them.
RGB
201
Rxi
BOO ST
LEV EL CON TRO L
PEA K
W ITH AD SP TM
CEN TER ING
Figure 2-4 — Through-desk mounting