Extron Electronics RGB 201 - Manual (Page 12)

RGB 201 Rxi Universal Interface • Introduction
Introduction, cont’d
RGBHV, RGBS, RGsB, or RsGsBs outputs — Select the output
format via cabling setup, rear panel DIP switch, and/or
internal DIP switch configuration.
• Sync on green — Sync can be added to the green video
signal, for an RGsB video output, by turning on a rear
panel DIP switch.
• Sync on red, green, and blue — Sync can be added to the
red and blue video signals, for an RsGsBs video output,
by turning on internal DIP switches and a rear panel DIP
switch.
Serration pulse switch — This DIP switch-selectable feature
adds or strips the serration pulses from the output signal
to make it compatible with digital display devices. Use
the serration pulse switch if flagging or bending occurs at
the top of the video display.
Sync polarity adjustment — Horizontal and vertical sync
output can either follow input sync polarity, or outgoing
sync can be forced to negative via an internal jumper.
Vertical sync pulse width adjustment — Vertical sync pulse
width can be adjusted via a rear panel DIP switch.
Vented metal enclosure — Vents in the enclosure keep the
interface cool and ready for use 24 hours a day, 7 days per
week.
Automatic sync stripping — Sync signals are automatically
stripped from the red, green and blue video input signals.
The interface normally outputs sync simultaneously as
separate horizontal and vertical sync and as composite
sync, but sync on green (SOG) and sync on red, green, and
blue can be selected on rear panel and/or internal DIP
switch(es).
1-4