Eagle Electronics FishElite - Manual (Page 74)

66
Sonar Features menu with Fish I.D. Depths selected (at left, dual-
frequency menu; center, single-frequency menu). When the check box to
the left is checked, the feature is on. At right, Sonar Page showing Fish
I.D. symbols and FishTrack depths turned on.
Frequency (Change Transducer Frequency)
(SeaCharter 500CDF only)
The SeaCharter 500CDF transducer operates with both 200 kHz and 50
kHz. The 200 kHz frequency has a 12
° cone angle and the 50 kHz fre-
quency has a 35
° cone angle.
The default frequency is 200 kHz, which is best for use in shallow water
(about 300 feet or less). This frequency is the best choice for about 80
percent of the fresh and salt water sport fishing applications. When you
get into very deep salt water, 300 to 500 feet or deeper, the 50 kHz fre-
quency is the best choice.
The 200 kHz transducer will give you better detail and definition, but
less depth penetration. The 50 kHz transducer will give you greater
depth penetration, but a little less detail and less definition. (Remember,
all sonar units typically read deeper in fresh water than in salt water.)
There is a common exception to these rules. Some fishermen on fresh-
water lakes (or the ocean) using downriggers like to see them on the
sonar. In many of those cases, you'll see a 50 kHz transducer frequency
in use because the wider cone angle lets them watch the bait.
Symbols with
FishTrack depths