Entering a password to use the projector – Epson PowerLite X49 3600-Lumen XGA 3LCD Projector User Manual
Page 125

125
Entering a Password to Use the Projector
If a password is set up and a
Power On Protection
password is enabled, you see a prompt to enter a
password whenever you turn on the projector.
You must enter the correct password to use the projector.
1.
Press and hold down the
Num
button on the remote control while you enter the password using the
numeric buttons.
Note:
The default password is
0000
.
The password screen closes.
2.
If the password is incorrect, the following may happen:
• You see a "wrong password" message and a prompt to try again. Enter the correct password to
proceed.
This manual is related to the following products: