Sony LHP-1 Lens Hood - Manual (Page 91)

3. Camera Operations: Technical Menu 91
Technical > Test Signals
Makes settings related to color bars.
Menu item Setting Description
Test Saw Type Saw /Step Saw Selects the type of test signal.
Saw: Output a saw wave as the test signal.
Step Saw: Output a step wave as the test
signal.
Technical > Special Configuration
Makes settings related to control of the unit.
Menu item Setting Description
RM/RCP Paint
Control On/ Off Turns the paint functions of an RM-B170 or
other remote control unit on/off.
[Note]
All settings on the unit are initialized when the RM/
RCP Paint Control setting is changed. However, RM/
RCP Paint Control and some other settings, such as
network settings, are not initialized.
NR(4K 17:9/16:9) On/ Off Turns the 4K 17:9/16:9 recording image noise
reduction on/off.
[Note]
Set to Off (fixed) when the following functions are
enabled.
• Select FPS
• Anamo. De-Squeeze: Settings other than Off(1.0×)
• Flip Image: Settings other than Normal
SD HDMI On/ Off Turns the function to set the HDMI output
signal to SD format on/off.
[Note]
Can be set to On when all the following conditions
are satisfied.
Imager Mode: 16:9 (including when Zoom to Fit is
set to 16:9)
Recording Format: X-OCN ST
Project Frame Rate: 50 or 59.94
360° Shutter Setting Pre Shutter On /Pre Shutter
Off
Turns the pre-shutter function on/off when
using 360° shutter angle (shutter off).
Pre Shutter On: Turn pre-shutter on.
Pre Shutter Off: Turn pre-shutter off.
[Note]
When set to Pre Shutter Off, an afterimage may
remain for one frame when an excessive amount of
light is incident, such as when shooting with a flash.