Sony LHP-1 Lens Hood - Manual (Page 88)

3. Camera Operations: Technical Menu 88
Technical > Network
Makes settings related to the network.
Menu item Setting Description
LAN DHCP ( On /Off) Sets DHCP.
When set to On, an IP address is automatically
assigned to the unit. To enter the IP address
of the unit manually, set to Off.
IP Address (DHCP/On: obtain
automatically , DHCP/Off:
192.168.2.50 )
Enter the IP address of the unit.
Enabled when DHCP is set to Off.
Subnet Mask (DHCP/On:
obtain automatically , DHCP/
Off: 255.255.255.0 )
Enter the subnet mask of the unit.
Enabled when DHCP is set to Off.
Wireless Network Mode ( Access Point /
Station)
Sets the network mode for wireless
connections.
Scan Networks (Run/Cancel) Scans for access points for connection
destinations (execute by selecting Run).
[Note]
Configurable only when Network Mode is set to
Station.
SSID When Network Mode is set to Access Point
Displays the SSID for the wireless
connection to the unit.
When Network Mode is set to Station
Displays/configures the SSID of the
connection destination access point.
[Note]
Valid characters for display and entry:
Alphabetic (A to Z, a to z)
Numeric (0 to 9 -.@—_())
Symbols (!"#$%&'*+,/:;<=>?[\]^`{|}~)
Technical > Network
Makes settings related to the network.
Menu item Setting Description
Password When Network Mode is set to Access Point
Displays the password for wireless
connection to the unit.
When Network Mode is set to Station
Configures the password of the
connection destination access point.
When entering a password, the asterisk
characters displayed are replaced by the
entered characters while the sub display
ITEM key 1 is pressed.
[Note]
Valid characters for display and entry:
Alphabetic (A to Z, a to z)
Numeric (0 to 9 -.@—_())
Symbols (!"#$%&'*+,/:;<=>?[\]^`{|}~)
WPS (Run/Cancel) Starts connection setup using WPS (execute
by selecting Run).
Channel (Auto(5GHz)/ Auto /
CH1/CH2/CH3/CH4/CH5/CH6/
CH7/CH8/CH9/CH10/CH11)
Sets the channel of the access point.
[Notes]
• Configurable only when Network Mode is set to
Access Point.
• Auto(5GHz) may not be displayed, depending
on the wireless LAN module being used. Check
whether use of the wireless LAN module is
supported in your country/region. For details,
refer to the operating instructions of the wireless
LAN module.
DHCP ( On /Off) Sets DHCP.
When set to On, an IP address is automatically
assigned to the unit. To enter the IP address
of the unit manually, set to Off.
[Note]
Configurable only when Network Mode is set to
Station.
IP Address (DHCP/On: obtain
automatically , DHCP/Off:
192.168.1.50 )
Enter the IP address of the unit.
Enabled when DHCP is set to Off.
[Note]
Configurable only when Network Mode is set to
Station.