Roland V-1SDI 4-Channel HD Video Switcher - Manual (Page 15)

15
Video Input/Output Settings
Adjusting Output Video
You can adjust the output video to match the
equipment receiving the output from the V-1SDI.
MEMO
5 You can output a color bar, useful for adjusting the
image quality of a display. Go to the SETUP menu, and at
SYSTEM (page 16/16), set “COLOR BAR OUTPUT” to “ON.”
1.
Display the SETUP menu (p. 12), then select a
menu item.
You use the following menu items to adjust the
output video.
VIDEO OUTPUT (page 3/16)
Menu item Explanation
3G-SDI MAPPING This sets the mapping structure for
3G-SDI output.
COLOR SPACE
This sets the color space for HDMI
output.
DVI-D/HDMI
This sets the output mode for HDMI
output.
VIDEO OUTPUT (page 4/16)
Menu item Explanation
CONTRAST (*2) This adjusts the contrast.
SATURATION (*2) This adjusts the saturation.
BRIGHTNESS (*2) This adjusts the brightness.
(*2) These settings are shared by HDMI output (the
MULTI-VIEW connector) and SDI output (the PGM
and PVW connectors).
2.
Use the A/B fader to adjust the output video.
* The settings for the following menu items are applied
by pressing the [DSK] ( ) button. If 15 seconds elapse
without applying the setting, the setting returns to its
original value, with no change applied.
5 VIDEO OUTPUT (3/16): COLOR SPACE
5 VIDEO OUTPUT (3/16): DVI-D/HDMI SIGNAL
3.
Quit the menu (p. 12).
Adjusting HDMI Input Video on
Channel 4
You can adjust image quality and set the EDID value
for video input via HDMI IN 4.
1.
Display the SETUP menu (p. 12), then select a
menu item.
You use the following menu items to adjust HDMI
input video on channel 4.
VIDEO INPUT (page 1/16–2/16)
Menu item Explanation
SCALING TYPE This sets the scaling type.
H. POSITION
This adjusts the display position in the
horizontal direction.
V. POSITION
This adjusts the display position in the
vertical direction.
ZOOM This adjusts the zoom ratio.
CONTRAST This adjusts the contrast.
SATURATION This adjusts the saturation.
BRIGHTNESS This adjusts the brightness.
FLICKER FILTER This reduces flicker.
EDID This sets the EDID value.
2.
Use the A/B fader to adjust the HDMI input
video.
3.
Quit the menu (p. 12).