Roland V-1HD+ Compact 4 x HDMI Video Switcher - Manual (Page 7)

7
Basic Operations
Turning the Power On/Off
Once everything is properly connected, be sure to
follow the procedure below to turn on their power. If
you turn on equipment in the wrong order, you risk
causing malfunction or equipment failure.
* Before turning the unit on/off, always be sure to turn
the volume down. Even with the volume turned down,
you might hear some sound when switching the unit
on/off. However, this is normal and does not indicate a
malfunction.
Turning the power on
1.
Make sure that all devices are powered-off.
2.
Turn on this unit’s [POWER] switch.
3.
Turn on the power in the order of source
devices 0 output devices.
Turning the power off
1.
Turn off the power in the order of output
devices 0 source devices.
2.
Turn off this unit’s [POWER] switch.
Operating the Menu
Here’s how to access the menu, and make video/
audio settings and settings for this unit.
The menu is shown on the monitor that’s connected
to the OUTPUT 2 connector.
1.
Press the [MENU] button to display the menu.
The menu is organized into functions.
2.
Turn the [VALUE] knob to select a menu item,
then press the [VALUE] knob to confirm.
3.
Repeat step 2 as needed.
Pressing the [MENU] button moves you back one
level higher.
4.
Turn the [VALUE] knob to change the setting
value, and then press the [VALUE] knob to
confirm.
MEMO
5 By turning the [VALUE] knob while pressing it,
you can change the value more greatly.
5 Long-pressing the [VALUE] knob returns the
current menu item you’re setting to its default
value.
5.
Press the [MENU] button several times to close
the menu.
About the Auto Off function
The power to the unit turns off automatically when
all of the following states persist for 240 minutes
(Auto Off function).
5 No operation performed on the unit
5 No audio or video input
5 No equipment is connected to the OUTPUT 1 and 2
connectors
If you do not want the power to be turned off
automatically, disengage the Auto Off function.
Use the [MENU] button 0 “SYSTEM” 0 set “AUTO
OFF” to “OFF.”
* Unsaved data is lost when the power turns off.
Before turning the power off, save the data that you
want to keep.
* To restore power, turn the power on again.