Ericsson R250s Pro - Manual (Page 15)

N
ot
fo
r
C
om
m
er
ci
al
U
se
E
ri
cs
so
n
M
ob
ile
C
om
m
un
ic
at
io
ns
A
B
12 Preparing Your Phone for Use
The system connector boot prevents connected accessories, e.g. a handsfree
set from falling out. When you use a portable handsfree and the phone is
attached to your belt, the handsfree will not fall out if you bend forward or sit
down.
The system connector boot also works as protection for the phone’s system
connector. With the system connector boot attached, you can charge the phone
outdoors, even if it is raining, or in a dusty environment without damaging the
phone’s system connector.
System Connector boot
SYSTEM CONNECTOR BOOT
1. Insert the handsfree plug or the
charger plug (or both) as shown in
the picture above. The flash and the
headset symbol must face upwards.
2. Pull the insert part of the system con-
nector boot through the system con-
nector boot and attach it to the
phone’s system connector, as shown
in the picture to the right.
3. Pull the system connector boot over
the insert part and the phone, until it
is properly attached.
4. To release the System connector boot
from the phone, push it upwards and
pull it out.