Instructions for use, Routine maintenance, Charging dock – Roborock S4 CE User Manual
Page 21: Main brush
Instructions for use
Charging dock
Routine maintenance
Main brush
* Weekly cleaning recommended
Note:
Main brush replacement every 6-12 months is recommended.
Main brush cover
Latch
Main brush cap
Main brush
Main brush bearing
Alignment mark
Lock direction
Unlock direction
Locator
beacon
More than 1m (3.3
ft
)
More than 0.5m (1.6
ft
)
More than 0.5m (1.6
ft
)
The charging dock should be plugged in and placed against a
wall on level ground, with more than 0.5m (1.6
ft
) of clearance
on each side, and more than 1m (3.3
ft
) in front. For the best
experience, when using the mobile app, place the charging
dock in an area with strong WiFi coverage.
1. Turn the robot over then unlatch and remove the main
brush cover.
2. Take out the main brush, remove and clean its bearings.
3. Remove the main brush cap rotating in the unlock direction.
4. Use the supplied main brush cleaning tool to remove any
entangled hair.
5. Re-install the cap and bearing following the lock direction.
6. Re-insert the main brush and replace the brush cover.
Note:
Do not place the charging dock in direct sunlight or block the locator beacon;
otherwise, the robot may not be able to return to the charging dock.
018