Instructions for use, Scheduled cleanup, Pin n go – Roborock S4 CE User Manual
Page 19: Cleaning mode virtual no-go zone and barrier, Zone cleanup

Instructions for use
Use the Mi Home app to set start times and suction levels for
scheduled cleanups. The robot will return to the charging dock
a
ft
er each cleanup.
Scheduled cleanup
Use the Mi Home app to set a destination for the robot. It will then go
to that point.
Pin n go
Use the Mi Home app to chose from Quiet, Balanced, Strong, or
MAX modes. The Balanced mode is the default.
Cleaning mode
Virtual no-go zone and barrier
Note:
The Mi Home app can be used to draw virtual no-go zones and barriers
to keep the robot from entering the areas you define.
Virtual barrier
Virtual no-go zone
Note:
While cleaning the designated zone, the robot may move outside zone borders.
Make sure that there are no cables or obstacles placed close to the cleanup zone.
Use the Mi Home app to draw a specific zone for the robot to clean.
Zone cleanup
In DND mode, no cleanups will start, no voice alerts will play, and the
power indicator will dim. DND mode is set from 22:00 to 08:00 by
default and can be disabled or modified in the Mi Home app.
"Map Saving Mode" must be turned on in the Mi Home app to use virtual no-go zones.
Virtual no-go zones and barriers should only be used to customize the cleaning area. It
should not be used to isolate hazards.
Moving the robot manually or making significant changes to the home environment may
cause the loss of virtual no-go zones and barriers
016