Roborock S4 CE - Manual (Page 17)

Instructions for use
On/o ff
Note: The robot cannot be turned o ff when it is charging.
Start cleanup
Note:
When the robot is cleaning, press any bu tt on to pause it.
Then press the bu tt on to continue cleaning or the bu tt on to stop
the cleanup and send it back to the dock.
Pause
Note: Placing a paused robot on the charging dock manually will end the current cleanup.
If the robot is paused for over 10-minutes, it will go to sleep, and its
power indicator will flash slowly. Press any bu tt on to wake it back up.
Sleep
Note:
Zone 1: Clean Zone 2: Clean
Zone 4: Pending Zone 3: Cleaning
Press and hold the bu tt on to turn on the robot. The power
indicator will turn on, and the robot will enter Standby mode. If the
robot is asleep, press and hold the bu tt on to turn it o ff and end
the current cleanup.
Press the bu tt on to start a cleanup. Once started, the robot will
plan its cleaning route based on its scan of the area. It cleans
along the wall of a zone first and then moves in a Z-shaped
cleaning route to cover the whole area e ffi ciently and thoroughly.
Cleaning cannot start if the ba tt ery level is too low. Allow the robot to charge before
restarting cleanup.
Tidy away any cables on the ground (including the power cable of the charging dock)
before cleaning to avoid losing power or damaging either the robot or any connected
devices.
If a cleanup finishes within 10 minutes, cleaning repeats by default.
If the ba tt ery runs low before cleanup is complete, the robot will carry out a top-up charge
before resuming cleanup from where it le ft o ff .
The robot will not go to sleep when it is on the charging dock.
The robot will shut down if le ft asleep for over 12-hours.
014