Is the detection range set correctly, Printing is not possible or, Stops during a job – Sharp MX-6070N User Manual

Page 12: Is a tray out of paper, Is the machine out of toner, Has a paper misfeed occurred, Is the output tray full, Is the waste toner box full, Copy, print, image send, and document filing), Printing is not possible or stops during a job

Is the detection range set correctly?

■ Adjust the detection range.

PRINTING IS NOT POSSIBLE OR STOPS DURING

A JOB

Check

Solution

Is a tray out of paper?

■ Add paper as instructed by the message in the touch panel.

Is the machine out of toner?

■ Replace the toner cartridge.

Has a paper misfeed occurred?

■ Remove the misfeed as instructed by the message in the touch panel.

Is the output tray full?

■ Remove the output from the tray and resume printing.

When the output tray becomes full, a detector activates and stops printing.

Is the waste toner box full?

■ Replace the waste toner box as instructed by the message in the touch panel.

Are restrictions placed on the trays
that can be used in each mode (copy,
print, image send, and document
filing)?

■ Check the settings in [Paper Tray Settings] and see if checkmarks appear in the

checkboxes of each mode ([Feeding Approved Job]).

Functions without a checkmark cannot be used for printing using that tray.
⇒ "Settings" → [System Settings] → [Common Settings] → [Paper Settings] →

[Paper Tray Settings] → [Tray Registration] → [Feeding Approved Job]

Check

Solution

Motion sensor

Near

Far