ProSoft Technology 5201-MNET-ASCII - Manual (Page 22)

Modbus TCP/IP Protocol Configuration MNET ♦ ProLinx Gateway
Driver Manual Modbus TCP/IP Interface Module
Page 22 of 78 ProSoft Technology, Inc.
September 1, 2010
2.4 [MNET CLIENT 0]
The [MNET CLIENT 0] section of the CFG file specifies the parameters for the
client to be emulated on the gateway. The command list for the client is entered
in a separate section.
2.4.1 Minimum Command Delay
0 to 32767
This parameter specifies the number of milliseconds to wait between the initial
issuance of a command. This parameter can be used to delay all commands sent
to slaves to avoid "flooding" commands on the network. This parameter does not
affect retries of a command as they will be issued when failure is recognized.
2.4.2 Response Timeout
0 to 65535 milliseconds
This is the time in milliseconds that a Client will wait before re-transmitting a
command if no response is received from the addressed server. The value to use
depends upon the type of communication network used, and the expected
response time of the slowest device on the network.
2.4.3 Retry Count
0 to 10
This parameter specifies the number of times a command will be retried if it fails.