ProSoft Technology MVI46-DFCM - Manual (Page 68)

MVI46-DFCM ♦ SLC Platform Reference
DF1 Communication Module
Page 68 of 103 ProSoft Technology, Inc.
October 20, 2008
Step Description
3 Presuming successful processing by the node specified in the command, a response
message is received into the Master driver for processing.
4 Data received from the node on the network is passed into the module's internal
database and the M1 file, assuming a read command.
5 Status is returned to the SLC processor for each command in the Master Command List.
Refer to DF1 Master Commands (page 70) for a complete description of the
parameters required to define the virtual DF1 master port. Refer to the DF1
Command Set for ProSoft Technology Communication Modules
documentation for a complete discussion of the structure and content of each
command. Care must be taken in constructing each command in the list for
predictable operation of the module. If two commands write to the same internal
database address of the module, the results will not be as desired. All commands
containing invalid data will be ignored by the module. The module does not
support the PLC-5 ASCII Address commands (150 to 152) as outlined in the DF1
Command Set documentation. The following table describes the functions
supported by the module and the format of each command:
Module Information Data Device Information Data
Col # 1 2 3 4 5 6 7 8 9 10 11
Function
Code Enable
Code Internal
Address Poll
Interval
Time Count Swap
Code
Node
Address Function
Code Function Parameters
FC 1 Code Register Seconds Count Code Node 1 Word
Address
FC 2 Code Register Seconds Count Code Node 2 Word
Address
FC 3 Code Register Seconds Count 0 Node 3 Word
Address
FC 4 Code Register Seconds Count 0 Node 4 Word
Address
FC 5 Code Register Seconds Count Code Node 5 Word
Address
FC 100 Code Register Seconds Count Code Node 100 File
Number Element Sub-
Element
FC 101 Code Register Seconds Count Code Node 101 File
Number Element Sub-
Element
FC 102 Code Register Seconds Count 0 Node 102 File
Number Element Sub-
Element
FC 501 Code Register Seconds Count Code Node 501 File
Type File
Number Element
FC 502 Code Register Seconds Count Code Node 502 File
Type File
Number Element Sub-
Element
FC 509 Code Register Seconds Count Code Node 509 File
Type File
Number Element
FC 510 Code Register Seconds Count Code Node 510 File
Type File
Number Element Sub-
Element
FC 511 Code Register Seconds Count 0 Node 511 File
Type File
Number Element Sub-
Element
Node Address = Destination Address for Message