Warm booting the module, Viewing network status, Viewing client status – ProSoft Technology MVI71-MNET User Manual
Page 48: Viewing client configuration, Viewing server configuration
MVI71-MNET ♦ PLC Platform
Diagnostics and Troubleshooting
Modbus TCP/IP Interface Module
User Manual
Page 48 of 109
ProSoft Technology, Inc.
June 23, 2009
Values at the bottom of the display are important in determining module
operation. The Program Scan Counter value is incremented each time a
module’s program cycle is complete.
Tip: Repeat this command at one-second intervals to determine the frequency of program
execution.
Warm Booting the Module
Caution: Some of the commands available to you from this menu are designed for advanced
debugging and system testing only, and can cause the module to stop communicating with the
processor or with other devices, resulting in potential data loss or other failures. Only use these
commands if you are specifically directed to do so by ProSoft Technology Technical Support staff.
Some of these command keys are not listed on the menu, but are active nevertheless. Please be
careful when pressing keys so that you do not accidentally execute an unwanted command.
Press [W]
from the Main Menu to warm boot (restart) the module. This command
will cause the program to exit and reload, refreshing configuration parameters
that must be set on program initialization. Only use this command if you must
force the module to re-boot.
Viewing Network Status
Press [1]
to view statistics for the network server ports. The Network Server
Ports Status screen shows the number of requests, responses, and errors for
each network server.
Viewing Client Status
Press [0]
(zero) to display the statistics of the client.
Viewing Client Configuration
Press [5]
to display the configuration information for the client.
Viewing Server Configuration
Press [6]
to view configuration information for the MNET Servers.