ProSoft Technology MVI56-BSAPS - Manual (Page 30)

MVI56-BSAPS ♦ ControlLogix Platform Module Configuration
Bristol Babcock Serial Slave Module
Page 30 of 83 ProSoft Technology, Inc.
September 22, 2008
2.4.6 Error/Status Block Pointer
1 to 7000
The Error/Status Block Pointer parameter is used to specify the range of
database registers to use for error and status data. The value should be no lower
than 700, to avoid overwriting data, and no higher than 6970, to allow sufficient
space for the error/status block.
2.5 [BSAPS Config]
This section is used to define the BSAPS configuration for the BSAPS device
simulated on network port
2.5.1 Number of Signal Value
0 to 255
2.5.2 Signal List Number
1 to 300
List Number is the MAX number of a range from 1 to MAX. Only one list can be
setup.
2.5.3 Array Element Row
Data Array Element Row ((Row * Column) <= Number of Signal Value)
2.5.4 Array Element Column
Data Array Element Column ((Row * Column) ≤ Number of Signal Value)
2.5.5 SFirmware Enable
0 = Disable, 1 = Enable.
This parameter enables the slave for longer messages on specific BSAP Master
devices.
2.5.6 Immediate Response Mode
0 = Disable, 1 = Enable.
This parameter enables slave immediate response.