ProSoft Technology MVI56E-GSC/ GSCXT - Manual (Page 56)

MVI56E-GSC Configuration MVI56E-GSC ♦ CompactLogix or MicroLogix Platform
User Manual Enhanced Generic ASCII Serial Communication Module
Page 56 of 140 ProSoft Technology, Inc.
May 9, 2014
Intercharacter Delay GSC.PortX.RDelay
Packet (String) Length GSC.PortX.RPacketLen
Streaming mode is not recommended for general use, as it creates heavy demands on the Control
Logix processor and requires time-critical programming logic to properly process.
2.2.3 Port[x].Baudrate
This is the baud rate to use on the port. Enter the baud rate (bits per second) as
a value. All devices on this port must communicate at the same baud rate. For
example, to select 19K baud, enter 19200.
The following table describes the valid parameters for this configuration entry.
Value Baud Rate (bits per second)
110 110 Baud
150 150 Baud
300 3000 Baud
600 6000 Baud
1200 1200 Baud
2400 2400 Baud
4800 4800 Baud
9600 9600 Baud
19200 19200 Baud
384 38400 Baud
576 57600 Baud
115 115200 Baud
2.2.4 Port[x].Parity
Parity is a simple error checking algorithm used in serial communication. This
parameter specifies the type of parity checking to use. All devices connected to
the port must use the same parity.
Value Description
0 None
1 Odd
2 Even
3 Mark
4 Space.
2.2.5 Port[x].DataBits
5, 6, 7 or 8
This parameter sets the number of data bits for each word used by the protocol.
All devices communicating through this port must use the same number of data
bits.