ProSoft Technology MVI69-103M - Manual (Page 12)

MVI69-103M ♦ CompactLogix or MicroLogix Platform Start Here
IEC 60870-5-103 Master Communication Module
Page 12 of 131 ProSoft Technology, Inc.
November 3, 2008
1.4 Install the Module in the Rack
This section describes how to install the module into a CompactLogix or
MicroLogix rack
Before you attempt to install the module, make sure that the bus lever of the
adjacent module is in the unlocked (fully right) position.
Warning: This module is not hot-swappable! Always remove power from the rack before
inserting or removing this module, or damage may result to the module, the processor, or other
connected devices.
1 Align the module using the upper and lower tongue-and-groove slots with the
adjacent module and slide forward in the direction of the arrow.
2 Move the module back along the tongue-and-groove slots until the bus
connectors on the MVI69 module and the adjacent module line up with each
other.